Toho-electronics TTM-P9 Uživatelský manuál

TOHO ELECTRONICS INC. Program Controller TTM-P4/P9 Series Instruction Manual Thank you for purchasing our Program Controller TTM-P4/P9 Series. P

9⑥ Common parameter setting mode (The SET lamp lights.) - This mode will set the parameter common to each pattern and step. From reset mode Hold t

10Set a time signal ON time. (This will not be displayed when an alarm output is selected.) Set a time signal OFF time. (This will not be displayed

11 When the automatic tuning is complete, the product will switch back to the automatic tuning startup screen. Automatic tuning possible even when lo

12 From reset modeHold the ▽ key and the PATT./STEP key down simultaneously. Set an alarm output lower limit. Set an alarm output upper limit. ↓ Pr

13PID setting parameters Description Initial value Character PID No. 1 (cold) 3 (hot) Setting range " □# Proportional band P 3.0% 3.0%

149. Specifications and Rating 9.1 General specifications Storage cell Each setting value is stored in EEPROM. Power supply voltage 100 to 2

15 9.2 Rating and performance Thermocouple Selection of thermocouples K, J, and R When a wire is disconnected: Indicated as "5555" Sa

11. Cautions on Use For safety purpose, following symbols are used in this manual. The case that a user may receive fatal damage, electric shock, o

22. Name and Size of Each Part 2.1 Name of each part LED Lamp RUN: Lights during operation mode OUT: Lights as synchronized with main contr

33. Wiring 3.1 TTM-P4 series SSR drive Control output Power supply voltage 100 to 240VAC ± 10% Relay contact Operation signal Output ReservedReserv

44. Terms and Functional Description 4.1 Event output 1. Deviation upper/lower limit 5. Absolute value upper/low

54.1 Wait operation In case one step shifts to another step, the next step will not start even after step time Elapsed if the process val

65. Before Program Operation You can select the input type. Three thermocouple types (K, J, and R) are provided for this product. In this Inst

7 6.2 Detailed description of modes ① Reset mode - This mode will stop control. (The system becomes this mode when the power is turned on.)

8⑤ Programming mode (The SET lamp lights.) - This mode will set the program for each pattern. - Setting the time to 0 minutes will invalidate tha